Fourth in this series of oscillators controlled by the DIY Quantussy and followed by Qu-Bit Data Bender, Make Noise Mimeophon, and Happy Nerding FX-Aid Pro. I got a little more … Read More

The previous post details the Flight of Harmony Famine 1500 build. Here it is, controlling all of my Ieaskul F. Mobenthey modules by Peter Blasser. For this patch I used … Read More

DIY Quantussy uses two of its oscillators for audio and the other three for modulation. The Ciat-Lonbarde quad VCAs are put to use. Two of them modulate the levels of … Read More

A little performance on Ciat-Lonbarde Sidrax. Pitches controlled by DIY Quantussy. Echos added by Make Noise Mimeophon. Recording and video have the same audio.

Updated: Added four more short takes. Controlling the IFM rack with Quantussy. Fourses outputs are level modulated and frequency modulated. FX added with uBurst Clouds. Some recordings drier than others.

Mido-based gear designed by Peter Blasser typically centers audio signals at a +4.5 volt bias, which Peter refers to as “mido”, i.e. middle. And these signals are roughly 4 volts … Read More

This patch uses two of the oscillators in the DIY Tetrazzi. These are each patched through a VCA channel of the new CL VCA and into my Eurorack effects case. … Read More

I noticed a problem with the DIY Quantussy right after I finished it. Chaos wouldn’t go all the way to zero. There was always a bit of cross modulation in … Read More

A few posts back I described an experimental VCA, based on the AVDog circuit by Peter Blasser in the Plumbutter. Our friend crucFx (Josh Rodriquez) offered to make a PC … Read More

A video and a recording