BugBrand Up and Running
BugBrand is nestled in a rack, sharing power with MOTM! I made a custom power cable with a MOTM connector and soldered it into the BB power distribution buss board. … Read More
BugBrand is nestled in a rack, sharing power with MOTM! I made a custom power cable with a MOTM connector and soldered it into the BB power distribution buss board. … Read More
I’ve admired the BugBrand Modular for a long time. It’s very rare and I was lucky to score a set of used modules. Left to right: SYN2A Utility VCO (x2) … Read More
I was adding a battery holder to my Plumbutter and decided to dress the wiring. It’s not a necessity, but I think it’s good to twist a ground with a … Read More
The MOTM Modular is 5U with 1/4-inch phone jacks for patching. The Cocoquantus has screw heads for alligator clip patching. For patching between these I have made up some simple … Read More
The FM mod for Cocoquantus is done by adding five input screws, each wired to a ready-to-wire CV input pad on one of the quantussy oscillators. I arranged the screws … Read More
I added a banana jack for ground to my Cocoquantus to more easily ground it to the modular. I connect together the grounds of the power supplies in my six … Read More
After I received my Ciat-Lonbarde Tetrazzi Organ, I spent a lot of time delving into its design. I wanted to understand it as well as possible in order to be … Read More
A picture of my studio in August, 2011. Left to right across the table are the M-Audio Axiom 25 MIDI controller, the Macbook Pro running Audio Mulch software with an … Read More
I populated a section of one of my cabinets with all of the modules I’ve built using the small knob format. From left to right: Mattson EG/VCA (2 modules) Mattson … Read More
Recently I had a couple of ideas that resulted in this project. I was putting the finishing touches on two CGS Serge VCS modules and started thinking about loading one … Read More